Dyna-Glo SIGNATURE Serie Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
3. Before attaching the rear legs, insert the bottom
shelf (Q) posts into the holes located on all four
legs. WIth the bottom shelf (Q) securely in place,
attach the left rear leg (S) and right rear leg (K)
using four M6 x 12 bolts (AA), four M6 nuts (BB)
and four M6 flat washers (CC), per leg.
Hardware Used
M6 x 12mm
AA
Bolt
M6 Nut
BB
M6 Flat Washer
CC
4. Insert the wheel axle (L) through the holes on the
right legs (K) and attach the left and right wheel (P)
using one M12 nut (DD) per side.
Hardware Used
M12 Nut
DD
x 8
x 8
x 8
x 2
7
3
AA
S
Q
K
4
K
DD
L
P