Dyna-Glo SIGNATURE Serie Mode D'emploi page 17

ASSEMBLY INSTRUCTIONS
23. Attach the temperature gauge (V) by inserting the
probe through the threaded opening on the lid (A1)
and turning clockwise. Do not remove the
pre-installed nut prior to attaching the gauge.
NOTE: The alignment of the temperature gauge
can be adjusted by turning the pre-installed nut
clockwise (or counter-clockwise) prior to install-
ing.
24. Install the offset cooking grates (A) on the top
support rails inside the offset smoker box. Install
the charcoal grates (Y) on the bottom support
rails inside the grill body (C). Install the primary
cooking grates (Z) on the top support rails inside
the grill body (C).
Optional Step for Installing the Damper Plates
Remove the primary cooking grates (Z) and lean
the large damper plate (E1) over the opening on
the inside of the grill body (C) as shown. The
remaining (small) damper plates (D1) can be
placed on the support rail as desired.
23
24
C
D1
17
V
A1
Z
A
Y
E1