Ingerev City Duo; Installing The Unit - Ingeteam INGEREV CITY Ground Manuel D'installation Et Usage

Ingeteam
3. Close the rear enclosure by fastening the eight tamper-proof Torx-type T30 bolts.
When a charging station is powered, the charging station light is activated. After briefly verifying its status, the
light will switch to green and the display will show an electric vehicle and the current time. The station is ready
and awaits identification from the user in order to begin charging.
If the station identifies any operating anomaly, the light turns red and the type of incident is shown on the display
(see "9. Operation").

7.3. INGEREV CITY Duo

7.3.1. Installing the unit

1. These charging stations have a back access with a key opening to facilitate the installation and
connections. Open the access using the key provided.
Proceed with fastening the unit to the ground. The following figure shows all the optional accessories
installed. These accessories are not essential in order for the charging station to operate correctly. If
you do not wish to install one or several accessories, follow the same installation diagram, omitting the
accessories that you do not require. To see a specific description for the installation of each optional
accessory, see section "7.3.2. Installing the optional accessories".
26
A
Installing and connecting the unit
B
ABA2020IQM01_B - Installation and Operation Manual
C