Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12.3
General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
Choose a level, shaking-free, non-slip surface as a place to set up.
•
Make sure you have enough space around the machine!
•
•
Ensure sufficient light conditions in the workplace to avoid stroboscopic effects!
Use only suitable tool that is free cracks and other errors (e.g. deformations).
•
Remove tools from the machine before turning it on.
•
•
Keep the area around the machine free of obstacles (e.g. dust, chips, etc.).
•
Never leave the running machine unattended.
The machine may only be operated, maintained or repaired by persons who are familiar
•
with it and who are aware of the dangers arising from this work.
Make sure that unauthorized persons maintain a corresponding safety distance from the
•
device, and in particular keep children away from the machine.
Wear suitable work clothes (eye protection, hearing protection, gloves duster mask, safety
•
shoes) as well as tight fitting work protection clothing – never loose clothes, ties, jewellery,
etc. – catchment hazard!
•
Hide long hair under a hair protector.
•
Do not remove splinters and chips by hand!
Refrain from working on the machine in case of tiredness, inconcentration or under the
•
influence of medication, alcohol or drugs!
Do not use the machine in areas where vapours of paints, solvents or flammable liquids
•
pose a potential hazard (fire or explosion hazard!).
Do not smoke in the immediate vicinity of the machine (fire hazard)!
•
•
Make sure the device is grounded.
•
Use only suitable extension cables.
Always disconnect the device from the power grid before cleaning, maintenance or repair
•
work and secure it against accidental reactivation
12.4
Electrical safety
Make sure that the machine is grounded.
•
Only use suitable extension cables.
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
•
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
Proper plugs and outlets reduce the risk of electric shock.
•
Water entry into the machine increases the risk of electric shock. Do not expose the
•
machine to rain or moisture.
The machine may only be used if the power supply is protected by a residual current circuit
•
breaker.
Use the machine only when the ON-OFF switch is in good working order.
•
Before connecting the machine always make sure that it is switches off.
•
12.5
Special safety instructions for this machine
Check the condition of the machine daily before and after use and do not put the machine
•
into operation before. During inspection, pay close attention to the connections, safety
devices and safety signs.
Secure the logs with the screw cap clamping device instead of using the hand or the help of
•
another person. This safety measure enables correct tool operation with both hands.
•
When handling coiled saw blades, take special care to prevent them from unrolling
uncontrollably to avoid the risk of injury.
Excessive noise can cause hearing damage and temporary or permanent hearing loss. Wear
•
hearing protection certified according to health and safety regulations to limit noise
exposure
Ensure that unauthorised persons maintain an appropriate safety distance from the
•
machine, and in particular keep children away from the machine.
HOLZMANN Maschinen GmbH
www.holzmann-maschinen.at
SAFETY
32
BBS810SMART_400V
Publicité
Table des Matières
