Electrical Connection - HOLZMANN MASCHINEN BBS810SMART 400V Mode D'emploi

14.3

Electrical connection

Dangerous electrical voltage!
 The machine may only be connected to the mains supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
Check, whether the neutral connection (if existing) and the protective grounding function
•
properly.
• Check, whether the supply voltage and the frequency correspond to the specifications of
the machine.
HOLZMANN Maschinen GmbH
WAR N I N G
www.holzmann-maschinen.at
10. Assembly the end stops on the
tracks
Fasten the four end stops (2x38, 39,
40) with screws and nuts (24) to
the ends of the tracks as shown.
11. Assembly clamping bracket/ stops
Insert clamp (30) into clamp holder and
fix with screw (S1).
Insert long stop (37) on log support and
fix with screw. Insert the short stop (27)
into the holder and also fix it with
screws (S1). The angular position of the
stops on the log support can be
adjusted using the two screws (S2).
12. Control of the sawblade distance. If
this is not identical on the left and
right, it must be adjusted at the
rear handle to either raise or lower
one side.
ASSEMBLY
41
BBS810SMART_400V