Connection Scheme; Receiver Interface / Rf - golmar C4+ Mode D'emploi

C4+ / DIRECTOR+ 1.0

1.3 CONNECTION SCHEME

1.3.1 RECEIVER INTERFACE / RF

Connect the radiofrequency device INTERFACE / RF to the terminals marked + - S located in the lower left part
of the plate, where + and – are the 12 v power supplied by the central and S, the input of the coded signal.
Do not place the INTERFACE / RF at less than 5 metres from any other receiver.
Note that with the same terminals we can connect in parallel up to 4 readers and one INTERFACE / RF.
INTERFACE/RF
GND
+12V
Power 12Vcc
COM
RELAY
NA
DOOR1
NC
COM
RELAY
DOOR2
BUS 485
CENTRAL 1 IN NETWORK MODE
FOR AUTONOMOUS MODE PALM
DOOR 1
DOOR 2
NA
NC
A
B
GND
6
DOOR 3
DOOR 4