Installation Of C4+ Central; Power Source And Wiring - golmar C4+ Mode D'emploi

C4+ / DIRECTOR+ 1.0
1.2 INSTALLATION OF THE C4+ CENTRAL
Disconnect the power before any manipulation of the installation in the central.
The central comprises two dif ferent pieces: a back cover and a front cover.
Pass the cables through the grooves of the back cover prepared for the purpose.
Close the box using the screw located in the central of the cover.
1.2.1 POWER AND WIRING
Connect the power cables to the terminals marked following the due instructions.
Remember that when working with direct current the positive is terminal number 1.
The correct power supply to the central can be checked by the illumination of the red led.
?? Power 12V – 2 A permanent (without battery) / Power 12V – 1.5 A regulated (without battery)
Enables connection of the central and 2 closure systems (electrolocks or electromagnets)
For more units, supply supplementary power.
?? Power 12V – 2 A permanent (with battery)
Enables connection of the central and 2 closure systems (electrolocks or electromagnets)
For more units, supply supplementary power.
Recommended cable in connections FTP 5 and above
The maximum distance recommended for the installation of the readers and press-buttons is 100 metres,
whether the installation of them is one after the other, or if the installation is made in radial mode.
Minimum Sections / Diameters of cables per conductor
ELECTRO STANDARD LOW
SYMBOL
CONSUMPTION
DIAMETER: 9/10
SECTION: 0.636mm²
DIAMETER: 14/10
SECTION: 1.5mm²
ELECTRO A CURRENT
500mA MAX. BREAKER
DIAMETER: 9/10
SECTION: 0.636mm²
DIAMETER: 12/10
SECTION: 1mm²
DOOR BUTTON (TO BE DEFINED)
PROXIMITY READER
ELECTROMAGNET 0.5A / 12Vcc
190mA
DIAMETER: 12/10
SECTION: 1mm²
DIAMETER: 14/10
SECTION: 1.5mm²
Important: For the reader and the
door button, the recommended cable
is section 0.636 mm2 (diameter 9/10)
5
DISTANCE IN
METRES
50
100
100