Section 5. Glossaries; Glossary Of Safety Delays And Lockouts - Zodiac AquaLink Z4 Manuel Du Propriétaire

Page 24
Section 5.
5.1

Glossary of Safety Delays and Lockouts

Lockouts
Any device can be locked out. This will prevent the locked out device from being
turned on manually. However, the device will turn on/off when it is being controlled
by a schedule.
Pool/Spa Switching Filter Pump Delay
The filter pump turns off while valves rotate between pool and spa to prevent
damage to the pool equipment. The valves take 35 seconds to rotate between pool
and spa; the filter pump will activate as soon as the valves have finished turning.
Heater Cool Down Delay
When the system is heating (water is circulating to the spa) and the Spa button is
pressed, the system will remain in Spa Mode for five (5) minutes, and will continue
to circulate the water. This delay allows water to cool the heater down by circulating
water through it, preventing equipment damage. The five (5) minute delay starts
counting down when the heater goes off. If the heater has been off for five (5)
minutes or more, prior to turning off the Spa, there will not be a delay.
Heater Start-up
The heater will only come on if the water is circulating (for example, the filter pump
is on and has been circulating for 15 seconds) to the corresponding body of water
(for example, spa for spa heater) and the actual water temperature is below the
temperature you set with Temp Set in the Menu. If these conditions are not met, the
heater will be enabled (ready to go), but will not fire.
Heater "Short Cycling" Prevention
When the heater is activated and the desired temperature is reached, heater will
turn off and remain off for three (3) minutes, even if the temperature falls below the
desired temperature. This feature prevents heater short cycling (in other words, the
heater turning off and on in rapid succession).
Cleaner Lockout
The pool cleaner will only activate if the system is in pool mode and water is
circulating. The pool cleaner requires that water is circulating to the pool in order for
it to operate. Return to pool mode to activate the cleaner.
ENGLISH
Glossaries
AquaLink AquaLink Z4 | Owner's Manual Z4 | Owner's Manual
® ®