Opening The Device; Surveying The Connection Area; Making The Electrical Connection - Kaco blueplanet 15.0 TL3 Mode D'emploi

7.2

Opening the device

NOTE
Removing the upper housing cover will invalidate the warranty.
Only ever release and remove the lower housing cover. Opening the upper housing cover will invalidate
your warranty.
↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 4 screws and carefully remove the housing cover [ T_30]
2 Be careful not to damage or soil the seal when setting the housing cover down.
» Proceed with the installation of the device.
7.3

Surveying the connection area

The connection for the AC supply is located inside the housing. The DC input source is connected to the housing base via
the solar plug connectors.
2
1
Fig. 9: Connection area
Key
1 DC isolator switch
2 8 (2x4) MC-compatible DC connectors for PV gener-
ator
3 AC connection terminal
7.4

Making the electrical connection

NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic condi-
tions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
7.4.1 Requirement for supply lines and fuse
DC-side
Max. conductor cross-section
Min. cable cross-section
Recommended cable type
KACO blueplanet 15.0 TL3 KACO blueplanet 20.0 TL3
3
4
5
4 Cable fitting (M40) for AC connection
5 Cable fitting (M16) for housing ground connection
dependent on the plug that is used
in accordance with local installation standards
solar cable
1 Housing cover
3 Screws for mounting
1
2
Page 17