Unpacking The Device; Fastening The Mount - Kaco blueplanet 15.0 TL3 Mode D'emploi

6.2

Unpacking the device

CAUTION
Risk of injury caused by excessive physical strain.
Lifting the device, for transport, relocation and assembly, can result in injuries (e.g. back injuries).
› Only lift the device using the openings provided.
› The device must be transported and installed by at least 2 persons.
Fig. 5: Unpacking the device
Key
1 Cardboard box cover
2 Protective packaging
3 Unit
Unpacking the device
1 Loosen packaging tape from cardboard box.
2 Open carton at the front.
3 Remove installation material and documentation.
4 Reach behind the housing and slide the device to the side and out of the carton.
5 Remove upper and lower protective packaging from housing.
6 Place the protective packaging back into the carton.
7 Lift the device at the intended positions.
» Continue mounting the device.
6.3

Fastening the mount

CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only suitable for masonry and concrete.
› Only install the device in an upright position.
Page 14
1
2
3
Fig. 6: Transporting the device
4 Centre of gravity of the device
5 Lifting positions
KACO blueplanet 15.0 TL3 KACO blueplanet 20.0 TL3
4
5