Chamberlain Internet Gateway; To Erase All Codes From The Door Control (Myq ® Control Panel) Memory - Chamberlain Rjo20C Mode D'emploi

Getting Connected
Internet Gateway
The Internet Gateway gives you control of your garage door from
your internet-connected computer or mobile device, letting you
use the myQ app to open and close your door, get alerts, and set
®
schedules from anywhere. You must have your Internet Gateway
set up in the myQ app to use it with the control panel.
®
Before you begin, you will need:
• Wi-Fi enabled smartphone or tablet
• Broadband internet connection and router
• myQ serial number located on the Internet gateway
®
Connect the Internet Gateway to your router and power. When
the green LED on the gateway has stopped blinking and glows
steadily, it is connected to the internet.
Setup and Connect Your Gateway and Opener in the myQ
1. Download the myQ
2. Follow the instructions given in the app to find and connect
your Internet Gateway.
3. Next, select the device you wish to add (Garage Door
Opener).
4. Once you select the opener in the app, you have 3 minutes
to press the LEARN button two times on the myQ
panel. The red LEARN LED will turn on. (Figure 2)
5. When the red LEARN LED turns off, programming is
complete. Once the opener is learned and appears in the app
device list, name your device (e.g., Garage Door Opener).
NOTE: If you are unable to add the myQ
Chamberlain Internet Gateway, erase all codes from the door
control and try again. Note that you will need to reprogram any
accessories you wish to use.
To Erase All Codes From the Door Control
(myQ Control Panel) Memory
®
Erase all remote controls and keyless entries:
1. Press and hold the LEARN button on the control panel until the
red learn LED goes out (approximately 6 seconds). All remote
control and keypad codes are now erased. Reprogram any
compatible accessory you wish to use.
Erase all devices (including myQ
1. Press and hold the LEARN button on the control panel until the
red Learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the
red Learn LED goes out. All codes are now erased. Reprogram
any compatible accessory you wish to use.
App and set up your account.
®
Control Panel to your
®
enabled accessories):
®
Figure 1
Router
Green LED
App
®
control
®
Figure 2
31
When the Chamberlain Internet Gateway
connects to the internet, the green LED
will stop blinking and will glow steadily.
®
myQ Control Panel
Power
Chamberlain
Internet
Gateway
Red Learn LED