Chamberlain RJO20C Mode D'emploi page 29

Programming
Your hand-held remote control (model 953ESTD) has already programmed to the door control (myQ
the factory. Below are instructions for programming additional remote controls and keypads.
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door
opener will NOT program accessories.
To Add a Remote Control or Keypad
REMOTE CONTROL
1. Press the myQ ® Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
KEYPAD
1. Press the myQ
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keypad. Then press the ENTER
button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
Command
LED (yellow)
Learn LED
(Red)
29
Control Panel) at
®
® Control Panel LEARN button twice, the
? ?
PIN
? ?