Publicité
Les langues disponibles
Les langues disponibles
Cable
Pulley
Weight
Use Gloves or
Cloth
Figure 5:
CABLE DRIVEN MOVEMENTS
Figure 6:
CHAIN DRIVEN MOVEMENTS
Chime
Rod
Chime
1/8"
Hammer
Stem
Chime Rods behind
the movement
Figure 7A
MOVING MOON DISC
Lunar time track or date track.
Coincides with the 29
1
/
2
day cycle of the phases
of the moon.
Figure 8
DO NOT REMOVE
STYROFOAM
PACKING BLOCK
*Note: When hanging
the weights, check the
hook on top and nut
on bottom to make
sure tight and secure
Chain
Chain Hook
Weight Hook
1/8"
Away
From
Rod
Chime Rods beside
the movement
Figure 7B
Moving Moon
STEP 3
HANGING THE WEIGHTS
(Figure 5 & 6)
DO NOT REMOVE THE STYROFOAM PACKING
BETWEEN THE PULLEYS AND THE CABLE DRUM ON
THE CABLE DRIVE MOVEMENTS. (SEE FIGURE 5 TO
IDENTIFY THE CABLE VERSION. SEE FIGURE 6 TO
IDENTIFY THE CHAIN VERSION.)
There are small identification stickers on the bottom of each
weight to tell you the position when it is hung in the clock. (R)
Right goes on the right as you stand facing the clock. (Next to
the hinges on the door) (C) is Center and (L) is left. It is
important to hang the weights in the correct position so your
clock will operate properly.
STEP 4
ADJUSTING CHIME HAMMERS
THIS ADJUSTMENT HAS BEEN MADE BY OUR CLOCK-
MASTERS BEFORE LEAVING THE
ADJUSTMENT SHOULD BE NEEDED UNLESS THE
HAMMERS
HAVE
ADJUSTMENT DURING TRANSIT OR DURING THE
UNPACKING PROCEDURE.
ADJUSTING THE CHIME HAMMERS TO THE CHIME
RODS.
Each hammer should rest (when not in motion) approximately
1/8" from the chime rod. Look to make sure each hammer hits
the rod squarely. If it does not, bend the stem of the hammer
gently until it is in the correct position.
STEP 5
SETTING THE MOON DIAL
(AVAILABLE ON SOME MODELS)
(Figure 8 & 9)
The moon dial corresponds with the lunar month and not the
calendar month. As long as the clock operates continuously the
moon dial will follow the moon through its phases
automatically. In order to set the moon follow these simple
instructions:
With your fingertips, apply slight pressure to the front of the
moon dial and rotate the moon dial clockwise until the moon is
directly below the #15 lunar day mark (each mark represents a
lunar day) on the lunar arch (See figure 9).
If the moon dial will not rotate, see the Trouble Shooting Section.
Refer to an almanac or calendar and determine the date of the last
full moon. Count the number of days past the last full moon.
Rotate the moon dial clockwise 1 lunar day for every day past the
full moon.
4
(Figure 7)
FACTORY. NO
BEEN
KNOCKED
OUT
OF
Publicité
