Nice MhouseKit SL1W Instructions Et Avertissements Pour L'installation Et L'utilisation page 32

LED P3
Off *
On
1 flash per second
2 long flashes
STOP LED
Off *
On
OPEN LED
Short beep + long beep at
the end of the manoeuvre
Short beep
Short beep
Short beep + long beep
Short beep
Prolonged 6 second beep
* or it could be in "Standby" mode
30 – English
Status
All OK
All OK
The device recognition phase has not been
carried out, or there are errors in the memo-
rized data
Devices recognition phase in progress
Status
All OK
All OK
Status
The automation has just completed a ma-
noeuvre or test phase
During wireless devices installation phase.
The control unit has learned the new wire-
less device
Indication resulting from battery insertion into
an accessory device, when the automation
is stopped. The battery has been inserted
into a wireless device known to the network
and the control unit has recognised it
Indication resulting from battery insertion
into an accessory device, when the auto-
mation is stopped. The battery has been
inserted into a wireless device known to the
network and the control unit has recognised
it but it is indicating that its battery is
empty.
A device has been deleted from the network
The procedure described in paragraph
10.3.5 is active, within which you can con-
firm deletion of a wireless network present
in the network.
Action
"Slow" speed selected
"Fast" speed selected
Run the recognition phase again (see paragraph 10.3.3 "Adding
further devices to an existing system").
Indicates that it is in the process of recognising the attached de-
vices (this will take a maximum of a few seconds).
Action
Cycle operation
Complete cycle operation
Action
Check led P1
Normal operation
Normal operation
Check the charge of the newly inserted battery
Normal operation