Nice MhouseKit SL1W Instructions Et Avertissements Pour L'installation Et L'utilisation page 23

PF: 24 V solar power system; useful when mains power is unavailable.
PT50W: Pair of 500 mm high columns with a photocell
For information about new accessories, refer to the Mhouse product cata-
logue or visit www.niceforyou.com.
10.2.1 - Installing the PR1 buffer battery (fig. 43)
CAUTION! - Electrical connection of the battery to the unit must
be performed exclusively after completing all stages in installation
and programming, as the battery is an emergency power supply.
To install and connect the PR1 buffer battery to the command unit, see
fig. 43 and refer to the PR1 instruction manual.
When the automation is powered by the buffer battery, 60s following
completion of a manoeuvre, the control unit automatically switches off
all the leds, with the exception of the "C" led on the control unit which
will flash more slowly; this is the "Standby" function. When a command
arrives, the control unit will reset to normal functioning (after a brief delay).
This feature is designed to reduce power consumption, as this is a very
important consideration with battery power.
43
44
10.2.2 - Install the PF solar power supply system (fig. 44)
CAUTION! - When the automation mechanism is powered by the
"PF" solar power system, IT MAY NOT BE POWERED by mains
power at the same time.
To connect the PF solar power supply system to the control unit, see fig.
44 and refer to the PF instruction manual.
When the automation is powered by the solar panel, 60s following com-
pletion of a manoeuvre, the control unit automatically switches off all the
leds, with the exception of the "C" led on the control unit which will flash
more slowly; this is the "Standby" function. When a command arrives, the
control unit will reset to normal functioning (after a brief delay). This feature
is designed to reduce power consumption, as this is a very important
consideration with solar power.
1
1
2
2
English – 21