16. WI-FI dongle usage
The WI-FI dongle offers WI-FI access point capability for connection to PC, Tablet or Smartphone. In addition to this function
•
it also offer the possibility to store and transfer a block of data from/to the RPC 5LGA regulator.
Insert the interface WI-FI into the IR port of RPC 5LGA regulator on the front plate.
•
Switch WI-FI dongle on by pressing the button for 2 sec.
•
Wait until the LINK LED becomes orange flashing.
•
Press 3 times consecutively and fast the dongle button.
•
At this point the display of the RPC 5LGA regulator shows the first of the 6 possible commands (D1...D6).
•
Press ▲▼to select the desired command.
•
Press
to execute the selected command. The unit will prompt for a confirmation (OK?). Press once again
•
confirm or
to cancel.
MODE
The following table lists the possible commands:
•
CODE
COMMAND
D1
SETUP DEVICE
D2
SETUP CX02
D3
CLONE DEVICE
D4
CLONE CX02
D5
INFO DATA CX02
D6
EXIT
17. Installation
RPC 5LGA regulator is designed for flush-mount installation. With proper mounting, it guarantees IP54 front protection.
•
From inside the panel, for each four of the fixing clips, position the clip in one of the two sliding guide, then press on the clip
•
corner until the second guide snaps in.
Push the clip forward pressing on its side and making it slide on the guides until it presses completely on the internal surface
•
of the panel.
• For the electrical connection see the wiring diagrams in the dedicated chapter and the requirements reported in the technical
characteristics table.
CX02
DEVICE
CX02
DEVICE
DESCRIPTION
Copies Setup settings from RPC 5LGA regulator to WI-FI dongle.
Copies Setup settings from WI-FI dongle to RPC 5LGA regulator.
Copies Setup settings and working data from RPC 5LGA regulator to
WI-FI dongle.
Copies Setup settings and working data from WI-FI dongle to RPC
5LGA regulator.
Shows information about data stored into WI-FI dongle.
Exits from dongle menu.
to
p. 34 / 60