Rapid Ct Set-Up - Icar RPC 5LGA Notice D'utilisation

Press ▲ ▼ to select the desired submenu (BAS
•
The following table lists the available submenus:
•
Press to access the submenu.
•
When you are in a submenu, the main display shows the code of the selected parameter (eg P.01 ), while the
•
numeric/alphanumeric displays at the bottom of the screen shows the parameter value and / or description.
Press to advance in the selection of items (such as scroll through parameters P.01
•
to go back to the previous parameter.
While a parameter is selected, with ▲ ▼ you can increase/decrease its value.
•
Once you reach the last parameter of the menu, by pressing
•
Using ▲▼select SAVE to save the changes or EXIT to cancel.
•
Alternatively, from within the programming, holding
•
If the user does not press any key for more than 2 minutes, the system leaves the setup automatically and goes back to
•
normal viewing without saving the changes done on parameters (like EXIT).
N.B.: a backup copy of the setup data (settings that can be modified using the keyboard) can be saved in the eeprom memory
•
of the RPC 5LGA regulator. This data can be restored when necessary in the work memory. The data backup 'copy' and
'restore' commands can be found in the Commands menu.

12. Rapid CT set-up

When the CT value is not known and only used at the moment of the installation, the P.01 parameter for CT primary can
•
remain set at OFF while all the others can be programmed.
In this case, during the system installation and once the controller is powered up, the display will show a flashing CT (Current
•
Transformer). By pressing ▲▼the CT primary can be set directly.
Once programmed, press
•
ADV
Cod Description
Access to Base menu
BAS
Accesso to Advanced menu
ADV
Accesso to Alarm menu
ALA
Access to Command menu
CMD
Access to Custom menu
CUS
Exits saving modifications.
SAVE
Exits without saving (cancel)
EXIT
MODE
Backward Decrement/increment Forward
to confirm. The unit will store the setting into P.01, and directly restart in automatic mode.
ALA ... ) that is shown on the alphanumeric display.
▼ ▲
once more will return you to the submenu selection.
for three seconds will save the changes and exit directly.
P02 P03... ), or press
p. 26 / 60
MODE