Keypad Lock - Icar RPC 5LGA Notice D'utilisation

Voltage
V
V HI
▼
Current
A
A HI
▼
Weekly PF
WPF
PF
▼
THD cap.
THDC
TC.HI
▼
Temperature
°C °F
°CHI
▼
°FHI
Voltage THD
THDV
VH02...
▼ ▲
...VH15
Current THD
THDI
IH02...
▼ ▲
...IH15
Cosphi
setpoint
IND
CAP
▼ ▲
Step power
%
▼ ▲
Step
counter
OPC
▼ ▲
Step hours
H
▼ ▲
These measures are shown only if the Step trimming function is enabled (P.25=ON) and the advanced password is enabled and entered.

7. Keypad lock

A function to exclude all modification to operating parameters can be enabled; measurement viewing is still provided in any
•
case.
To lock and unlock the keypad, press and keep
•
and after that release
MODE
RMS voltage of the plant current.
Maximum voltage value measured.
RMS current of the plant voltage.
Maximum current value masured.
Weekly average power factor.
Instantaneous total power factor.
Capacitors total harmonic distortion (THD) in current.
Maximum THD value measured.
Temperature of internal sensor.
Maximum temperature value measured.
Total harmonic distortion % (THD) of plant voltage.
% voltage harmonic content from 2.nd up to 15.th order
Total harmonic distortion % (THD) of plant current.
% Current harmonic content from 2.nd up to 15.th order
Setting of desired cosϕ setpoint (same as P.19).
Step residual power, as a percentage of the set rated power.
Operation counter of the step.
Hour meter of the step insertion.
.
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
MODE
key pressed. Then press the ▲ key three times and the ▼key twice
MODE
p. 23 / 60