Dustbane Gladiator 512 Manuel D'opération page 17

Fuse blown.
Motor malfunction.
Filter shaker switch not pressed.
Filter shaker motor faulty.
Damaged belt.
Side flaps damaged.
Bin full.
Filter incorrectly positioned.
Worn gaskets.
Fuse blown.
Motor malfunction.
Alarms Displayed, 512 Ride-On
Alarm Problem
Acc Accelerator
Pot Potentiometer
Lim Limitation
Hot Overheating
MoS Mosfet
bLt Drive block
PROBLEM:
The center brush does not turn.
CAUSE
PROBLEM:
Filter shaker not working.
CAUSE
PROBLEM:
Side brush does not turn.
CAUSE
PROBLEM:
The machine raises dust.
CAUSE
PROBLEM:
Dust comes out of the fan.
CAUSE
PROBLEM:
Drive motor does not work.
CAUSE
Description
Appears if the accelerator knob (fig. A, ref. 9) is activated before the machine is turned on or
after the emergency button has been reset. Release the accelerator knob then action again.
Appears if the speed potentiometer malfunctions or is faulty. The drive has stopped. Release
the knob then action again. If the message continues, the potentiometer could be faulty.
Appears when a mosfet internal thermal limitation problem occurs. The drive has stopped.
Release the accelerator knob then action again. If the problem continues, wait for a few
minutes.
When the motor overheat sensor trips, wait for a few minutes for the motor to cool down.
Appears when the mosfet is in short circuit. All machine functions are shut down.
Appears when the battery voltage is too low. Recharge the batteries.
Replace fuse.
Replace the motor.
Press the filter shaker switch.
Replace filter shaker motor.
Replace the belt.
Replace flaps.
Empty the bin.
Remove the filter and replace correctly.
Replace gaskets.
Replace fuse.
Replace the motor.
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
17