Publicité
Les langues disponibles
Les langues disponibles
Rear Bin:
•
Release the bin by lifting and turning the two clips (fig. B, ref. 13) 512-712.
Release the bin by lifting and turning the two clips (fig. A, ref. 14) 512 Ride-On.
•
•
Grip the bin and remove it from the machine.
•
Empty the bin.
•
Replace the bin.
•
Block the bin in place by turning the two clips and pressing them when in position.
Stopping
•
Move the machine to the parking area.
•
Stop the machine by releasing the handle (fig. B, ref. 9) 512-712, releasing the accelerator knob (fig. A, ref. 9) 512 Ride-On.
Turn off the brushes using the button (fig. C, ref. 3) 512 Ride-On.
•
Stop suction (fig. C, ref. 9) 512-712.
•
•
Lift the side brush using the lever (fig. A/B, ref. 11).
•
Turn the key switch (fig. C, ref. 1) to the "0" position.
Periods Of Inactivity
1.
Disconnect the battery. To optimize the working life of the battery, it should be charged every 30/40 days.
2.
Empty the bins.
3.
Clean the machine in general.
4.
Clean the suction filter.
Maintenance Instructions
Maintenance on the electrical circuit and all other operations not explicitly described in this manual must be performed
by specialized personnel only, in compliance with current safety legislation and as described in the maintenance manual.
Never perform any maintenance operations without first disconnecting the batteries from the machine's electrical circuit.
Maintenance - General Rules
Performing regular maintenance according to the Manufacturer's instructions improves performance and extends the working life
of the machine. When cleaning the machine, respect the following:
1.
Avoid the use of high pressure washers. Water could penetrate the electrical compartment or motors leading to damage or the
risk of short circuit;
2.
Do not use steam to avoid the heat warping plastic parts;
3.
Do not use hydrocarbons or solvents as they could damage the cowling and rubber parts.
Routine Maintenance
External side brushes: replacing
1.
Rotate the cowling.
2.
Remove the back wheels.
3.
Unscrew the screws fixing the flap to the chassis (ref. 1).
4.
Replace with new flaps.
11
Publicité
