Publicité
Les langues disponibles
Les langues disponibles
Working
If you are using the machine for the first time, we recommend trying it on a large obstacle-free surface first to acquire the necessary
familiarity.
Starting Up/Use 512 Ride-On:
The seat has a safety sensor which allows the machine to move only when the operator is seated.
Prepare the machine as described in the above paragraph.
•
Lift the side brush using the lifting lever.
•
Turn the key switch to the "1" position.
•
Check the LEDs to make sure the battery/ies is sufficiently charged. If not, charge the batteries.
•
Press the brush button when the brushes are active, the LED on the button comes on. Pressing it again stops the brushes, the
suction motor comes on automatically.
•
Use the accelerator knob to activate the drive.
To set the maximum operating speed, proceed as follows:
1.
With the machine off, turn the key switch (fig. C, ref. 1) to the "1" position.
2.
Move forwards with the machine using the accelerator knob (fig. A, ref. 9) to select the required maximum speed, then move
the drive selector (fig. C, ref. 7) to the centre position. Memorising of the speed is indicated by a beep.
To reset the maximum operating speed set by the manufacturer, turn the machine on and off using the key switch (fig. C, ref. 1) or
repeat the instructions in point 2, turning the accelerator knob (fig. A, ref. 9) as far as it will go (MAX. SPEED). Reverse speed cannot
be changed.
•
Adjust pressure of the centre brush on the floor using the knob according to the type of floor and dirt to be picked up. Turn it
clockwise to increase pressure and anticlockwise to reduce pressure on the work surface.
•
Lower the side brush using the lever.
•
Start cleaning, manoeuvering the handgrip with the hands and acting on the drive control.
Starting Up/Use 512-712
•
Prepare the machine as described in the above paragraph.
•
Lift the side brush using the lifting lever.
•
Turn the key switch to the "1" position.
•
Check the LEDs to make sure the battery/ies is fully charged. If not, charge the batteries.
•
Use the lever to activate the drive.
•
Press the suction button.
•
Adjust pressure of the center brush on the floor using the knob according to the type of floor and dirt to be picked up. Turn it
clockwise to increase pressure and anticlockwise to reduce pressure on the work surface.
•
Lower the side brush using the lever.
•
Start cleaning, maneuvering the handgrip with the hands and acting on the drive control.
To avoid damaging the surface of the floor to be treated, avoid rotating the brushes with the machine stationary. Do not pick up wire,
string or plastic straps. Each 30 minutes of work, activate the filter shaker button (fig. C, ref. 4) for 30 seconds to clean the suction filter.
During this operation, the suction fan shuts off automatically. Avoid passing over puddles. If the work surface is wet, you can use the
machine only by turning off the suction fan (fig. C, ref. 2) as damp/wet dirt reduces the performance of the suction filter.
Emptying The Debris Bin
Before emptying the bin, make sure all machine functions are turned off.
When emptying the bin, always wear a mask to protect the respiratory tract from the dust which is always present during this operation.
Front Bin:
Use the handle to release the bin (fig. B, ref. 12) 512-712.
•
•
Use the handle to release the bin (fig. B, ref. 13) 512 Ride-On.
•
Grip the bin and slide it out.
•
Empty the bin.
•
Replace the bin.
Use the handle to block the bin in place (fig. B, ref. 12) 512-712.
•
Use the handle to block the bin (fig. A, ref. 13) 512 Ride-On.
•
10
Publicité
