Dustbane Gladiator 512 Manuel D'opération page 13

• Lift the front of the machine.
• Unscrew the screw (ref. 1), remove the worn brush.
• Install the new brush and fix it with the screw (ref. 1).
• Unscrew the two screws (ref. 1), adjust the height of the brush and tighten the screws.
Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be Identified and repaired. Have the machine
checked by qualified personnel.
Fuses: Replacing
1. Turn the key switch to the "0" position.
2. Rotate the cowling to access the machine compartment.
3. Remove the fuse holder cover.
4. Check the fuses.
5. Replace with a new fuse.
6. Close the cover again.
Fuse table: For the complete fuse table, see the parts list.
Side Brush Belt: Replacing
1. Rotate the top cowling.
2. Remove the pulley (ref. 2) belt (ref. 1).
3. Unscrew the fixing pin (ref. 3) and side arm hooks (ref. 4) from the idle toothed ring.
4. Remove the belt (ref. 1) from the side arm (ref. 4).
5. Replace the belt.
6. Attach the side arm (ref. 4) to the idle toothed wheel again.
7. Screw up the pin (ref. 3).
8. Fit the belt (ref. 1) onto the pulley (ref. 2).
13