Dustbane Gladiator 512 Manuel D'opération page 16

Damaged belt.
Side flaps damaged.
Bin full.
Filter incorrectly positioned.
Worn gaskets.
Fuse blown.
Microswitch under seat not pressed.
Drive motor overheated.
Heat sensor damaged.
Damaged drive board.
Motor malfunction.
Accelerator, potentiometer, malfunction.
Troubleshooting, 512-712
Battery disconnected.
The battery is flat.
The key switch is in the 0 position.
Fuse FU4 blown.
Fan switch on OFF.
Motor malfunction.
16
PROBLEM:
Side brush does not turn.
CAUSE
PROBLEM:
The machine raises dust.
CAUSE
PROBLEM:
Dust comes out of the fan.
CAUSE
PROBLEM:
Drive motor does not work.
CAUSE
PROBLEM:
The machine does not function.
CAUSE
PROBLEM:
Suction motor does not function.
CAUSE
Replace the belt.
Replace flaps.
Empty the bin.
Remove the filter and replace correctly.
Replace gaskets.
Replace fuse.
Sit correctly on the seat.
Turn off the machine and wait for a few minutes.
Replace heat sensor.
Replace drive board.
Replace the motor.
Replace potentiometer.
Connect the battery to the machine.
Recharge the battery.
Turn the key switch to the "1" position.
Replace fuse FU4.
Press the fan switch.
Replace the motor.
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION