Installing The Remote Controller - Hitachi R410A Manuel D'installation

9.1. Installing the remote controller

Open the operation panel on the front of the remote control-
ler, remove the 2 screws indicated in the following ¿ gure, and
then remove the front case of the remote controller.
When installing the remote controller, remove the connector
from the front case. The wires may break if the connector is
not removed and the front case hangs down.
When installing the front case, connect the connector to the
front case.
SET BACK
Screws
When remote controller cable is concealed
(1) Conceal the remote controller cable.
(2) Pass the remote controller cable through the hole in the
rear case and connect the remote controller cable to the
remote controller terminal board speci¿ ed in ¿ gure.
(3) Clamp the remote controller cable sheath with the binder
as shown in ¿ gure.
(4) Cut off the excess binder.
(5) Install the rear case to the wall, box, etc., with 2 screws
¿ gure.
1. Red
Hole
Binder
(Small)
[Example]
Box
Rear case
En-14
9374318438-05_IM.indb 14
Front case
(back side)
Rear case
Connector
2. White
3. Black
CAUTION
When connecting the
remote controller wires, do
not overtighten the screws.
Remote
controller cable
Connector
Screws
120 (4-23/32)
30
(1-3/16)
Hole
CAUTION
Install the remote controller wires so as not to be
direct touched with your hand.
Do not touch the remote controller PC board and PC
board parts directly with your hands.
17
(21/32)
33.5
(1-5/16)
23
(29/32)
8
(11/32)
4.5 (3/16)
6
(1/4)
Hole × 2
Hole × 3
Unit: mm (in.)
9/10/2010 11:10:11 AM