Do You Want To Have The Current Plant Data Displayed - Siemens Synco 700 Manuel D'utilisation

Do you want to have the current plant data displayed?

If you are on the start display (welcome picture), you
only have to press the INFO button and you will be on
the information level . Here, you find the key plant data
listed.
Please note: The display depends on the type of plant.
You cannot change any values here!
Now, press the INFO button. This will take you step by
step from one info page to the next.
Each page is numbered.
The ESC button will take you straight back to the start
display.
You reach the Info page only from the start display! However, if you press the INFO button while one of the menus is
displayed, it is not the current plant data that appear, but a help display for each data point with the cursor. The help
display shows the path you have followed thus far and the correct data point name.
14
Siemens Building Technologies / HVAC Products
You can display the following data, for example:
• Room operating mode (preselection, state, cause)
• Time switch
• Controller 1: Actual values and currently active set-
points, e.g.: For the room and supply air temperture
• Controller 2: Actual values and currently active set-
points, e.g.: for the room humidity
• Device state (fault code , date, etc.)
CE1B3144x2 74 319 0350 0 16.05.2003