GGM gastro HB364M Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien page 35

Set the temperature by pressing the INCREASE
the desired temperature of 185% and wait for the TEMPERATURE/PROGRAMMES display (10) to stop
flashing
(the temperature will this way be set and the TEMPERATURE/PROGRAMMES display (10) will display
again the temperature present in the cooking chamber
The RESISTORS icon
cooking chamber)
To set the time press the TIME button
display (9)) press the INCREASE
of 18 minutes and wait for the TIME/HUMIDITY display (9) to stop flashing (the time will be set)
Set the humidity pressing the HUMIDITY button
TIME/HUMIDITY display (9)) press the INCREASE
the desired humidity value OFF (off, 20%, 40%, 60%, 80%, 100%) and wait till the TIME/HUMIDITY
display (9) stops flashing
Press the STEPS button
the programming of the third step)
Set the temperature by pressing the INCREASE
the desired temperature of 190% and wait for the TEMPERATURE/PROGRAMMES display (10) to stop
flashing
(the temperature will this way be set and the TEMPERATURE/PROGRAMMES display (10) will display
again the temperature present in the cooking chamber
The RESISTORS icon
cooking chamber)
To set the time press the TIME button
display (9)) press the INCREASE
of 5 minutes and wait for the TIME/HUMIDITY display (9) to stop flashing (the time will be set)
Set the humidity pressing the HUMIDITY button
TIME/HUMIDITY display (9)) press the INCREASE
the desired humidity value OFF (off, 20%, 40%, 60%, 80%, 100%) and wait till the TIME/HUMIDITY
display (9) stops flashing
At the end of the programming, to store you have to hold the PROGRAMMES
until the buzzer rings.
On the TEMPERATURE/PROGRAMMES display (10) appears the number of the selected programme
and on the TIME/HUMIDITY display (9) appears MEM (memorised).
will turn green to indicate that the set temperature is higher than that of the
(it will make the message END flash on the TIME/HUMIDITY
or DECREASE
(on the TIME/HUMIDITY display (9) the
will turn green to indicate that the set temperature is higher than that of the
(it will make the message END flash on the TIME/HUMIDITY
or DECREASE
or DECREASE
buttons until you reach the desired time
(will make the message OFF flash on the
or DECREASE
is now lit up, which indicates
or DECREASE
buttons until you reach the desired time
(will make the message OFF flash on the
or DECREASE
buttons until you reach
buttons until you reach
buttons until you reach
buttons until you reach
button down
35