Setting A Value Of Temperature; Setting A Value For Cooking Time; Manual Humidification While Cooking - GGM gastro HB364M Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien

Other phases that make up the programme are adjustable (F1, F2, F3) as described in section 3.2
- To store hold the PROGRAMMES button
with the sound of a buzzer for a couple of seconds and by the display showing the number of the previously
selected programme
WARNING:
- A single push of the PROGRAMMES button
to MANUAL cooking mode. The TEMPERATURE/PROGRAMMES display (10) shows the temperature in
the cooking chamber (TEMPERATURE icon
value of the first ignition (00:00) (CLOCK icon
A single push of the START/STOP button
If the location where you chose to save the recipe was already taken, you lose the previous recipe.
At any time, pressing the ON/OFF button
will be lost.

3.2 SETTING A VALUE OF TEMPERATURE

Pressing the INCREASE
temperature value (temperature range adjustable from 30°C - to 260°C).
A timeout of five seconds or pressing the TIME
from the ON/OFF button
the cooking chamber (TEMPERATURE icon
Once the data is confirmed, the display of the values is fixed.

3.3 SETTING A VALUE FOR COOKING TIME

As described in section 2.2 SETTING OF A COOKING TIME in the MANUAL cooking version.

3.4 MANUAL HUMIDIFICATION WHILE COOKING

With the card ON press the HUMIDITY button, the HUMIDITY
in red shows the OFF value. Pressing the INCREASE
reset the desired humidity value.
Humidity range from OFF to 20%, 40%, 60%, 100%.
100% = water solenoid 6 seconds ON, 20 seconds OFF
80% and 60% = water solenoid 4 seconds ON, 20 seconds OFF
40% and 20% = water solenoid 2 seconds ON, 20 seconds OFF
OFF = humidification only in manual mode.
During the modifications, the visualisation of the values in the display is flashing.
The confirmation of the value occurs when you press the HUMIDITY button
down for 4 seconds. The successful saving is confirmed
flashing) and the TIME/HUMIDITY display (9) shows the
starts the cooking programme.
puts the card in OFF and the settings which are not saved
or DECREASE
) confirms the set value and redirects you to the instantaneous temperature in
flashing).
allows you to exit the programming mode and to return
lit).
buttons immediately allows you to set the
, HUMIDITY
display (HUMIDITY icon
or DECREASE
, PHASES buttons (apart
button allows you to
.
flashing
32