GGM gastro HB364M Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien page 33

After confirming, the HUMIDITY display disappears (HUMIDITY icon
display (CLOCK icon
Press the START/STOP button
set values are between 20% and 100% and the actual temperature in the cooking chamber has exceeded
the 90°C value.
HUMIDITY icon
indicate the off time of the solenoid valve.
In the case the 'reverse' fan/motor rotation is changed the humidification is momentarily interrupted and will
then automatically resume.
MANUAL HUMIDIFICATION DURING COOKING
While cooking, holding down the HUMIDITY button
you to activate, at any time, the manual humidification for the duration you keep the two buttons down.
While the humidification is active in the oven, the HUMIDITY icon
In the case the 'reverse' fan/motor rotation is changed the humidification is momentarily interrupted and will
then resume if the two buttons are still pressed.
3.5 STEPS OF COOKING IN A PROGRAMME
When you choose the PROGRAMMES mode, the STEPS button
make up the programme. By pressing the button you can go from one step to the next (the step in which you
find it is indicated by the STEPS icons
stage you can modify the following parameters: time, temperature and humidity.
3.6 RECALL PROGRAMME ALREADY STORED
To recall a cooking programme already stored you need to follow these guidelines:
- A single push of the PROGRAMMES button
TEMPERATURE/PROGRAMMES display (10) (PROGRAMMES icon
appears flashing.
Increasing up to the value of the recipe to recall ES P25 and after a 5-second timeout that recipe is
confirmed (or press the PROGRAMMES button
- It will only appear on the display1 ES P01 with its related icons all off as is on the display2.
- A single push of the PROGRAMMES button
TEMPERATURE/PROGRAMMING display (10) (PROGRAMMES icon
- With the INCREASE
steadily lit in red).
to start a cooking cycle; it also initiates the humidification cycles if the
is steadily lit in red only when the humidification is active, flashing (0.5on - 0.5off) to
or DECREASE
together with the DECREASE
is on steady red.
: if you are in phase 1, the red light is on). At each
allows you to enter the programming mode. In the
). In the displays the data related to it will appear.
allows you to enter the programming mode. In the
buttons you can select the desired programme number.
is off) and appears the TIME
button allows
allows you to see the steps that
steadily lit in green) the P01
lit in red) appears "P01".
33