Setting A Value Of Temperature; Setting A Value For Cooking Time; Manual Humidification While Cooking - GGM gastro HB364M Manuel D'instructions Pour L'installation, L'utilisation Et L'entretien

2.1 SETTING THE VALUE OF TEMPERATURE
When the oven is ON, pressing the INCREASE
to set a temperature value (temperature range adjustable from 30°C - to 260°C). In the case of first ignition
(first ignition means whenever you put the oven ON by pressing the ON/OFF
TEMPERATURE/PROGRAMMES display (10) (TEMPERATURE icon
(30° C) value.
Or else, in case that I have just finished a cooking cycle appears on the display flashing the value previously
set.
During the modifications, the visualisation of the values in the display is flashing.
A timeout of five seconds or pressing the TIME button
display of the instantaneous temperature in the cooking chamber (flashing TEMPERATURE icon
Confirmed the data, the visualisation of the values is steadily displayed.
Pressing the ON/OFF button

2.2 SETTING A VALUE FOR COOKING TIME

To set a cooking time, press the TIME button
red)shows the value of END. Time range adjustable from 00h01mins - to 15h59mins.
Pressing the INCREASE
When going under a minute END is displayed and subsequently INF.
END is used in the programmed cooking with steps to disable the phase.
INF means that you have selected an infinite time, which means that the oven will always work until it is
stopped by pressing the START/STOP button
During the modifications, the visualisation of the values in the display is flashing.
The confirmation of the value is done by pressing the TIME
Once the data has been confirmed, the visualisation of the values on display is steady.
CLOCK icon steadily lit up in green.
Pressing the ON/OFF button

2.3 MANUAL HUMIDIFICATION WHILE COOKING

puts the card in OFF and the new settings are not saved.
the TIME display (9) (CLOCK icon
or DECREASE allows you to set a value to the time.
.
puts the card in OFF and the new settings are not saved.
or DECREASE
steadily lit) is shown flashing the
confirms the set value and returns to the
button, or after a 5-minute timeout.
buttons immediately allows you
button) the
steadily lit up in
).
28