Setup; Important Notes - Kollmorgen SERVOSTAR 300 Serie Manuel

2.7 Setup

For step-by-step setup guidance refer to the Instructions Manual.

2.7.1 Important Notes

Only professional personnel with extensive knowledge in the fields of electrical engineering
and drive technology are allowed to test and set up the drive.
There is a danger of serious personal injury or death by electrical shock. Lethal danger exists
at live parts of the device.
Built-in protection measures such as insulation or shielding may not be removed.
Work on the electrical installation may only be performed by trained and qualified per-
sonnel, in compliance with the regulations for safety at work, and only with switched off
mains supply, and secured against restart.
Risk of death or serious injury for humans working in the machine. The servo amplifier might
restart automatically after power on, voltage dip or interruption of the supply voltage, depend-
ing on the parameter setting. If parameter
then place a warning sign (Warning: Automatic Restart at Power On) to the machine.
Ensure, that power on is not possible, while humans are in a dangerous zone of the
machine.
If the servo amplifier has been stored for longer than 1 year, then the DC bus link capacitors
will have to be re-formed. To do this, disconnect all the electrical connections.
Supply the servo amplifier for about 30 minutes from single-phase 230VAC to the terminals
L1 / L2. This will re-form the capacitors.
The adaptation of parameters and the effects on the control loop behavior are described in
the Online Help
DANGER
Lethal Voltage!
WARNING
Automatic Restart!
of the setup software.
S300 Product Safety Guide | 2 English
AENA is set to 1,
Kollmorgen | kdn.kollmorgen.com | November 2018 55