To Set Up The Frx Trainer - Philips HeartStart FRx Trainer Mode D'emploi

6
FRx TRAINER 861306
• Internal Manikin Adapter [REF: M5088A]
• Replacement FRx Trainer carry case [REF: 989803139531]

To set up the FRx Trainer

To install or replace the batteries
The HeartStart Trainer is powered by four AA alkaline batteries (not
included). To install or replace the batteries, follow the steps below:
1. Press the latch on the battery compartment door on the back of the
FRx Trainer. Lift off the door and set it aside.
2. Remove the old batteries and recycle or dispose of in accordance with
your local regulations.
3. Insert four new AA alkaline batteries into the recess, oriented as
illustrated in the battery holder.
4. Replace the battery compartment door and press down to ensure the
latch holds it in place.
NOTE: It is recommended that you replace all four batteries at the
same time.
To connect or replace the Training Pads II
To connect the Training Pads II to the FRx Trainer, simply plug the Training
Pads II connector into the connector port of the FRx Trainer. Be sure the
connector clicks into place.
When the original training pads have reached the end of their service life,
you can order Replacement Training Pads for the training pads case.
To install replacement training pads in the reusable training pads case,
remove and discard the old pads from the case. Open the Replacement
Training Pads II package and remove each training pad from the disposable
liner. Repack the replacements pads in the reusable case according to the
following directions.