Philips HeartStart FRx Trainer Mode D'emploi page 11

To repack the Training Pads II
1. Firmly press one pad into each side of the open training pads case.
2. Untwist the pads wires if necessary.
3. Coil the pads wires inside the case with the connector plug exiting
through the hole in the pads case.
To use the FRx Trainer with Laerdal training manikins
To simulate the patient, use the Training Pads II on a CPR training manikin
equipped with a disposable External Manikin Adapter M5089A or an
Internal Manikin Adapter M5088A. Alternatively, you can use a Laerdal
Resusci Anne training manikin equipped with Laerdal Link technology and
an adapter available at most electronics stores. Contact Philips for
information.
To install the external manikin adapter
The M5089A External Manikin Adapter is provided with the FRx Trainer. It
can be applied to any training manikin as illustrated in steps 1 and 2 below.
(When the manikin is used in training, Training Pads II should be placed as
shown in step 3 below.)
Applying the External Manikin Adapter M5089A to an adult manikin.
NOTE: The M5089A External Manikin Adapter has a limited service life.
You can order replacement sets of five adapters.
7