Product Identifi Cation Label - EMAK CHEYENNE 92 Manuel D'utilisation Et D'entretien

*ATTENTION: Due to construction design reasons the machine does not permit the
disconnection of the front axle drive – the hydraulic system is not equipped with
a by-pass valve, which significantly limits the option of moving the machine when the
engine is not running. During such movement the front axle is significantly overloaded
and may be damaged. The by-pass lever on this machine is primarily used to bleed the
hydrostatic system.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the
disengaged position - there is a danger of damage to the transmissions!!
1.3 Product identifi cation label and other labels with symbols used on the
machine
1.3.1 Product identifi cation label
Every riding mower is marked with a product identification label, located behind the seat. It can be
accessed by moving the seat forward.
1. Machine model
2. Engine model
3. Year of production
4. Weight
5. Name and address of the manufacturer
1.3.1 6. EC codes used to assess the product's compliance
7. Compliance mark of the product
8. Logo of the manufacturer
9. Guaranteed noise level according to directive 2000/14/EC
The seller will write down the serial number on the other side of the front page of this
manual when handing over the machine.
1.3.2 Other labels and their meanings
The following labels and stickers are attached to the machine:
u Labels on the mowing deck:
1.3.2a
u Labels on the fairing under the steering wheel:
1.3.2b
Danger
Rotating tools
Danger
Do not leave the
machine when
driving
Do not mow near
other people
Keep unauthorised
persons at a safe
distance
Do not step on
Guaranteed noise
level
100
dB
Do not touch
during operation
Caution, deflected
objects
Do not take on
passengers
Maximum working
MAX
o
18 incline
63
Before cleaning
or repairing the
mower, stop
the engine and
disconnect the
spark plug lead.
Read the manual
Mow upwards and
downwards (the
slope), not side-
ways