EMAK CHEYENNE 92 Manuel D'utilisation Et D'entretien page 80

(12) Mowing deck elevation adjustment lever
The lever serves to set the elevation height of the mowing deck from the ground.
When travelling without mowing the lever must be set to the transport position!
The mulching function can be improved on 92 4x4 machines by using a special accessory,
a so-called „mulching set", which is supplied separately as a special accessory for mowing
maintained lawns.
(13) Choke
For starting a cold engine:
(14) Differential lock lever
The lever is used only if necessary and only when driving directly forward. It has two positions:
Use the lock only when driving directly forward and only if necessary (loss
of traction). Never use the differential lock when changing travel direction.
Otherwise there is a risk of serious damage to the transmission!
The lever has 4 working positions. The higher the lever position, the
higher the vegetation height that remains after mowing. The position values
based on the mowing deck model are:
Machine 92 4x4:
55 - 82 - 110 – 138 mm, which corresponds to the mowing height of 5.5
to 13.8 cm.
Machine 110 4x4:
45 - 70 - 98 – 130 mm, which corresponds to the mowing height of 4.5
to 13 cm.
There is also 1 transport position, which is:
- 165 mm above the ground for machine 92
- 158 mm above the ground for the 110 machine.
When the lever is set to the transport position it is not possible to engage
the mowing deck as a safety switch is built into this position.
CHOKE
Pulling the lever upwards and holding it there will engage the lock.
When the lever is released the lock is automatically disengaged
Starting a cold engine
80