How To Listen To The Fm Radio; Setup And Special Configurations - Midland BTX1 PRO S Guide D'utilisation

light will flash.
› Follow now the pairing procedure explained on the manual of the transcei-
ver itself.

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch
to the "FM Radio" mode in order to use it. Long press the middle button until
you hear "FM radio" from the voice announcement. Now all the three main
buttons are dedicated to the FM Radio (See Table C).
Press short the Forward or the Backward button to seek the FM Radio station.
When you press long the Forward or the Backward button, you can scan up or
down the 6 recorded stations. A voice announcement will tell you the number
of which memory you are entering.
To save the station you are listening to, press the Forward and Backward but-
tons together for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal
available for the radio station you like to listen. The RDS system is OFF by de-
fault, if needed you can toggle on/off the RDS pressing together the "Volume
+" and "Volume –" buttons for 3 sec when the radio is on. A voice announce-
ment will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" but-
ton about 7 sec., until the Red light is on permanently.
C-Radio FM mode
Mode
FM Radio
www.midlandeurope.com
Forward button
Short press: seek station up
Long press: Scan recorded
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue
LED will flash three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the
Midland BTX1 PRO S.
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
› To exit the "Setup" mode, double click the "Middle" button.
FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the in-
tercom, you can only open it using VOX feature (just talk) to the unit paired
on the "Middle" button. To manually activate the intercom you must switch to
"Intercom" mode.

Setup and special configurations

Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing references sto-
red in the Midland BTX1 PRO S unit (reset operation).
To perform this operation you must first enter the setup mode:
› Turn off the unit.
› Press and hold down the "Middle" button 7 sec., until the Red light is on
permanently.
› Then simultaneously press and hold down the "Volume +" and "Volume –"
buttons for 3 seconds. The Blue Light will be lit on for 1 sec and than back
to steady RED.
› Double click on the "Middle" button to exit the "Setup" mode.
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
29