How To Listen To The Fm Radio - Midland BTX1 PRO Guide D'utilisation

GPS navigator always in background
To keep the intercom open while the GPS gives the street indication you must have the
"background" feature active and the GPS paired on "Vol-" button
Attention: we can't guarantee this features because is depending on third part device
GPS Stereo (A2DP) voice announcement
BTX1 PRO support Stereo (A2DP) voice announcement from GPS Navigators or smar-
tphone application when paired on "Vol+" button. When a voice announcement "brake in",
Intercom or FM radio is interrupted to give priority to the announcement itself. By default
this feature is ON; it's possible to change the priority using the "BT Updater" PC Software
or BT SET-APP smartphone application.

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch to the "FM
Radio" mode in order to use it. Long press the middle button until you hear "FM radio"
from the voice announcement. Now all the three main buttons are dedicated to the FM
Radio (See Table).
Press short the Forward or the Backward button to seek the FM Radio station. When
you press long the Forward or the Backward button, you can scan up or down the 6
recorded stations. A voice announcement will tell you the number of which memory you
are entering.
To save the station you are listening, press the Forward and Backward buttons together
for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for
the radio station you like to listen.
Radio FM mode
Mode Forward button
FM Radio Short press: seek station up
Long press: Scan recorded
24
The RDS system is OFF by default, if needed you can toggle on/off the RDS pressing
together the "Volume +" and "Volume –" buttons for 3 sec when the radio is on. A voice
announcement will tell you the RDS status.
FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the intercom, you can
only open it using VOX feature (just talk) to the unit paired on the "Middle" button. To
manually activate the intercom you must switch to "Intercom" mode.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about 7
sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will flash
three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the BTX1 PRO.
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
› To exit the "Setup" mode, double click the "Middle" button.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button. If paired on
"Volume -" and the "Background" feature is activated, the PMR446 radio is always in
the background even when you talk on the intercom.
Middle button
Short press: On/off
Long press: Change mode
Backward button
Short press: seek station down
Long press: Scan recorded
www.midlandeurope.com