Pairing The Midland Btx1 Pro S To Bluetooth Devices; Background Feature - Midland BTX1 PRO S Guide D'utilisation

Talk2All-Universal Intercom
Not Midland Intercom
Attention: remember to switch OFF all other Bluetooth devices during the pai-
ring procedure, only the two devices involved in the pairing must be turned on.
To open/close the "Universal Intercom" communication on the Midland BTX1
PRO S press very long (7 sec) in "Intercom" mode the Forward button. On
the other intercom just press the phone redial or voice dial button.
Maybe it will be necessary to press the redial button two times, depending on
the model of the not Midland intercom.
Attention: In order to use the "Talk2All-Universal Intercom" feature the pairing
on the other unit must be done as a phone. The other intercom (not Midland
brand) will be able to be paired to a phone only if two phones are supported.
You can pair also a Midland unit as Talk2All, that means the pairing must be done
as a phone (one unit use the Talk2All procedure and the other unit use the pairing
to "Phone" procedure).
Compatibility with Midland BT line units
The BTX1 PRO S is compatible with Midland BT devices. When paired the max
distance of the intercom is defined from the lower possible.
The BTX1 PRO S is compatible with the previous line of Midland BT (BT Next,
BTX2 and BTX1) only if you update the firmware.

Pairing the Midland BTX1 PRO S to Bluetooth devices

The Midland BTX1 PRO S unit can be paired to other Bluetooth devices, like
Phone, GPS Navigator or PMR446 Radio with built-in or external Bluetooth
(dongle).
The pairing procedure must be done using the "Volume +" or the "Volume -"
buttons.
› Pairing to the "Volume +" button: for Phone with music A2DP stereo,
www.midlandeurope.com
GPS Navigator with A2DP audio or external mono/Stereo A2DP dongle.
All devices paired to "Volume +" button have higher priority and will inter-
rupt all the other communications (like Intercom, FM Radio and Music).
› Pairing to the "Volume -" button: for a second phone with mono audio
(Hands Free Protocol) for GPS navigators/ Radar detector and other de-
vices with mono audio.
MONO
› Phone (HFP Mono)
› GPS mono
› PMR446 transceiver
When a device is paired to the "Vol +" or "Vol –" buttons the "Phone" mode
is activated.
Attention: A2DP audio source are supported only on Vol+. The second phone
paired on Vol- can support only mono audio (HFP).

Background feature

It is possible to keep always in background the audio connection of the devi-
ce paired on "Vol-" button. In this way the Intercom communication will not
be interrupted, for example, by the GPS's street indication or or other audio
mono device. To activate the "Background" feature just press long the "Vol-"
button, the voice "Background ON" will tell you that now is active.
To deactivate the "Background" feature just press again long the "Vol-" but-
ton, the voice "Background disable" will tell you that now is not active anymore.
Pairing with one or two phones
The cellular phone can be paired to the "Vol +" (if the support for stereo A2DP
is requested) or to the "Vol –".
STEREO
› Phone (HFP/A2DP Stereo)
› GPS (HFP/A2DP Stereo)
› Dongle (HFP/A2DP Stereo)
25