Burner Cap Placement - Bosch NGM30 Manuel D'installation

Burner Cap Placement

9 WARNING
To prevent flare-ups, do not use the cooktop without
all burner caps and all burner grates properly
positioned.
9 WARNING
To prevent burns, do not touch burner caps or
grates while hot. Turn the cooktop off and allow the
burners to cool.
Do not attempt any adjustment of the pressure regulator,
except conversion to propane.
The burner caps must be properly placed for the cooktop to
function properly. If the burner cap is not properly placed,
one or more of the following problems may occur:
Burner Base
• Burner flames are too high.
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
Placing Burner Caps
Each cap has a letter (A, D, or F) cast in the underside of
the cap that corresponds to a letter (A, D, or F) cast in the
burner base that is attached to the appliance.
• After electrical connection is complete, place each
burner cap on its correct burner base per its
corresponding letter designation. See figure "Burners
Caps" on page 7.
• Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
Burner Cap
Matching letter
designation.
Figure 9: Burners Caps
English 7