Troubleshooting - Scheppach OSM600 Instructions D'origine

16. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem
Motor doesn't start
Machine gets slower during
work.
Sanding belt comes off the
drive pulleys.
The wood gets burnt during
sanding.
Strong vibrations
28 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
ON/OFF switch damaged.
ON/OFF cable damaged
ON/OFF relay damaged
Fuse blown
Motor burnt
Too much pressure put on the work-
piece.
Belt does not run straight.
Sanding disc or belt covered with
grease.
Excessive pressure on workpiece.
Loosely mounted tool
Defective tool
Spindle knocks
Help
Replace all damaged parts before you use
your machine again.
Contact your local service centre. Every at-
tempt to carry out a repair, can be dangerous if
it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
Replace disc or belt.
Reduce pressure on workpiece.
Tighten tool
Change tool
Repair at a Service-Station