Technical Data - DS Produkte VR-101A Mode D'emploi

EN
ERR6 The motor of the roller brush is
overloaded.
ERR7 The dust bin is not properly
inserted in the dust compartment.
ERR8 Malfunction of the sensor detection
for avoiding collisions.
ERR9 Both wheels
touching the fl oor.
ERR10 The sensors on the front and back
are no longer in contact with the
ground.

Technical data

Device
Model number:
Product number:
Diameter:
Height:
Rechargeable battery: 14.4 V; Li-Ion
Capacity of the
rechargeable battery:
Rechargeable battery
charging time:
Operating time:
Voltage supply
– charging station:
– the remote control: 3 V DC (2 x 1.5 V batteries, type AAA)
Mains adapter
Model number:
Voltage supply:
Safety class:
06025_DE-GB-FR-NL_A5_V5.indb 42 06025_DE-GB-FR-NL_A5_V5.indb 42
42
Switch the device off and wait
at least 30 minutes before you
reactivate the device and use
it again.
Open the dust compartment
and correct the position of the
dust bin.
Clean the sensors on the
bottom side of the device
(see chapter "Cleaning and
maintenance").
are no longer Lift the device up and set it
down somewhere else on the
fl oor. If necessary, remove the
obstruction.
Lift the device up and set it
down somewhere else on the
fl oor.
VR-101A
Z 06025
33 cm
9 cm
2200 mAh
4 – 9 hours
approx. 100 minutes on hard fl oors
approx. 25 minutes on carpeting
18.0 V DC, 1.5 A
HYCH0301801500G
100 – 240 V~ 50 / 60 Hz
II
Customer service/
importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
*) Calls subject to a charge.
24.04.2015 10:12:26 24.04.2015 10:12:26