DS Produkte VR-101A Mode D'emploi page 39

6. Loosen the catch on the HEPA fi lter and pull it off. The dust fi lter is located
behind it.
7. Empty out any coarse dirt over a waste bin.
8. Insert both fi lters again. When inserting the fi lters, make sure that they
are properly secured!
9. If necessary, clean the dust bin with clean, warm water. Then let it dry
completely before putting it back in the device.When putting it back in the
device, make sure that the dust bin is properly seated in the dust bin
compartment and that the handle is folded down.
10. Close the cover. It must audibly lock into place.
Cleaning the roller brush, rubber strip and nozzles
Over time, hair, threads or other dirt and debris may collect on the roller brush.
To remove them, take the roller brush out of the device.
If the roller brush is worn out, it must be replaced. A spare roller brush is included
in the product contents.
1. Remove any coarse dirt from the bottom side of the device.
2. Place the device upside down on the ground or a table.
6. Then put the brush back in the holder and the compartment. Make sure that
the side of the brush with the square is inserted in the corresponding recess
in the compartment.
7. Place the cover with the rubber strip back on the compartment and push it
into place. The cover must audibly lock into place.
Replacing the side brushes
If the side brushes are worn, they must be replaced. Two spare side brushes
are contained in the product contents.
1. Remove any coarse dirt from the bottom side of the device.
2. Place the device upside down on the ground or a table.
06025_DE-GB-FR-NL_A5_V5.indb 39 06025_DE-GB-FR-NL_A5_V5.indb 39
39
3. Release the cover with the rubber strip (11) by pushing
the two catches together and folding the cover up.
4. Carefully take the roller brush (10) out of the
compartment.
5. Use the enclosed cleaning brush or a cloth to clean
the cover with the rubber strip, the roller brush, the
compartment and nozzles.
3. Use a star-headed screwdriver to loosen the screws
on the side brushes.
4. Pull the side brushes off of the axles.
5. If necessary, clean the brush compartments.
6. Place the new side brushes on the axles and tighten
the screws.
EN
24.04.2015 10:12:25 24.04.2015 10:12:25