Maintenance; Accessories - Ryobi PGC21B Manuel D'utilisation

 Replace the outer blade washer. Double "D" flats on blade
washers align with flats on spindle.
 Depress spindle lock button and replace blade bolt.
CAUTION:
Always install the blade with the blade teeth and the
arrow printed on the side of the blade pointing up at the
front of the saw.
 Tighten blade bolt securely.
NOTE: The blade bolt has left hand threads. Turn blade
bolt counterclockwise to tighten.
 Close blade bolt door and tighten the screws securely.
TO REMOVE / REPLACE THE THROAT PLATE
See Figure 20, page 20.
WARNING:
The throat plate must be below the saw table. If the throat
plate is too high or too low, the workpiece can catch on
the uneven edges resulting in binding which could result
in serious personal injury.
Never operate the saw without a throat plate installed.
The following recommended accessories are currently available at retail stores:
Saw Blade ....................................................................................................................................................... 089230100053
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or ac-
cessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended
can result in serious personal injury.

MAINTENANCE

ACCESSORIES

NOTE: ILLUSTRATIONS BEGIN ON PAGE 19
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
To remove / replace:
 Remove the battery pack.
 Remove the screws securing the throat plate.
 Lift the throat plate from the saw. Repeat the above steps
for the left side of the throat plate.
 To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw base.
 Retighten the screws, being careful not to overtighten
which can cause the throat plate to bow or bend.
TO ADJUST LOWER ROLLER
See Figure 21, page 21.
 Loosen both nuts on lower roller.
 Move the bolt that secures the roller. in or out to adjust
the saw until it is square to the saw table.
TO ADJUST THE SLIDE RAIL
See Figure 22, page 21.
The slide rail should travel the entire length of the saw as-
sembly and be perpendicular to the fences.
 Use the two oval slots on the underside of the rail mounts
located under the saw to adjust the slide rail so that it is
square to the fences.
 Use a framing square to align the blade to the miter/cross
cut fence at a 90° angle.
Page 17 — English