Assembly - Ryobi PGC21B Manuel D'utilisation

PACKING LIST
See Figure 2, page 16.
The following items are included with the saw:
Key
No. Description
A Miter/Cross Cut Fence ........................................1
B Fence Lock Knob ................................................2
C Dust Bag ..............................................................1
D Rip Cut Fence ......................................................1
E Push Stick ...........................................................1
F Work Clamp .........................................................1
G Combination Wrench ...........................................1
H Extra 5/8" Arbor Spacer .....................................1
Operator's Manual (not shown) ...........................1
UNPACKING
This product ships completely assembled.
 Carefully lift saw from carton and place on a level work
surface.
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 The saw is factory set for accurate cutting. After assem-
bling it, check for accuracy. If shipping has influenced the
settings, take to an authorized service center.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.

ASSEMBLY

WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
Qty.
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
When using saw on a table or workbench, stand at a 45
degree angle to the saw. Do not allow hands to come
closer than 4 in. (100 mm) to the blade. Do not reach
over or across the blade. Failure to heed this warning
can result in serious personal injury.
WARNING:
The saw ships with both fences installed on the saw table,
however when using the saw, only one fence can be used
at a time. Do not use both fences at the same time.
Page 11 — English