Adjustments; Maintenance; Accessories - Ryobi P501 Manuel D'utilisation

ADJUSTING POSITIVE 0° BEVEL STOP
 Loosen bevel adjustment knob.
 Turn setscrew with hex key and adjust base until it is
square with the saw blade.
 Tighten bevel adjustment knob securely.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
The following recommended accessories are currently available at retail stores:
 5-1/2 in. Thin Kerf Blade
 Edge Guide (Part No. 6795708)
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or ac-
cessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended
can result in serious personal injury.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 14 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
All manuals and user guides at all-guides.com

ADJUSTMENTS

MAINTENANCE

ACCESSORIES

13
WARNING:
Attempting a bevel cut without having the bevel ad-
justment knob securely tightened can result in serious
injury.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion and nickel-cadmium batteries must
be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/
or serious injury.