Publicité
Les langues disponibles
Les langues disponibles
FILLING UNIT WITH WATER
CAUTION: When filling, never pour
water directly into the vapor outlet or
transducer when power is supplied and
unit is on. This could damage the unit.
Do not allow water to spill onto
controls. Never add essential oils or
other solutions directly to the water. It
can damage the plastic seals and
cause leaks.
1) Lift off the vapor nozzle and
place in a safe location.
2) Remove the essential oil tray
from the top of the water tank.
3) Lift water tank up using handle and turn
tank upside down to expose fill cap.
4) Remove cap and fill the water tank with fresh, cool water. Always use two
hands when carrying a full tank.
5) Wipe any spilled water from exterior of tank and screw water cap back onto
tank. Verify cap is tightly installed back onto water tank before replacing it
onto base.
6) Invert tank and replace it onto base ensuring sections align. Add essential
oil to aroma tray as desired, and replace the tray on the tank.
Visit www.aircareproducts.com or call 1.800.547.3888 to order essential
oils.
NOTE: The water tank and base only go together one way.
CAUTION: After the water tank is filled and placed on the base, do not attempt to
move the humidifier. Leakage will occur.
OPERATION
After filling and placing the unit in an appropriate location, plug in the Spire for use.
NOTES:
7)
When power is applied, the red power button will blink when unit has no
water.
8)
Front buttons are unresponsive until prepared by the remote control. See
below.
9)
For first use of buttons, press firmly. For subsequent use, the buttons are
touch sensitive.
5
Publicité
