Lap-Shoulder Belt Installation - Britax Emblem Guide D'utilisation

BRITAX Child Safety, Inc.

Lap-Shoulder Belt Installation

1. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow
and unbuckle the
harness.
2. The anti-rebound bar is
required for rear facing
installations. Attach the
anti-rebound bar (see
page 26).
IMPORTANT: Keep
fingers away from the anti-
rebound bar connection
points to avoid finger
entrapment or pinching.
3. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
24). Ensure that no more
than 7.6 cm (3 in.) of the
base hangs over the edge
of the vehicle seat.
4. Pull the head restraint/
head pad cover up,
then pull the seat cover
forward to access the
rear-facing belt path.
5. If applicable, open the
blue lock-off closest to
where the vehicle belt will
be buckled (see page 24).
a. Open the locking tab.
b. Open the clamp.
6. Route the vehicle belt
through the rear-facing
belt slots, ensuring that
the vehicle belt is routed
under the harness buckle
strap.
NOTE: The buckle should
be in the inner slot.
7. Ensure the vehicle belt is
not twisted and buckle
the seat belt.
10
7.6 cm
5b
5a
Clamp
Locking
Tab
EMBLEM/ALLEGIANCE Canadian User Guide
8. Push down into the
middle of the child
seating area with
moderate force while
removing all slack from
the bottom (lap) part of
the vehicle belt and close
the lock-off (see page 24).
IMPORTANT: Both the
vehicle lap and shoulder
belts must be routed
through the lock-off.
9. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off.
10. Replace the seat cover
and infant positioning
pillow, if required (see
page 24).
Rear-Facing Installation with Lap-Shoulder Belt
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 7.6 cm (3 in.) of the base hangs
over the edge of the vehicle seat.
9 Ensure that the anti-rebound bar is properly installed
(see page 26).
9 Check that the child seat cannot be moved front to back
or side to side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 The child seat is correctly installed when angle guide line
is parallel to the ground when the car is parked on a level
surface. After the child is secured, the recline angle of the
child seat should be 30° – 45° from vertical (not to exceed
45°) when the car is parked on a level surface. See "Seat
Positions" on pages 24 - 25.
9 Ensure tether webbing is stored in storage pouch. See
page 30.
11