Rear-Facing Installation; Luas Installation - Britax Emblem Guide D'utilisation

BRITAX Child Safety, Inc.

Rear-Facing Installation

IMPORTANT: The provided infant positioning pillow must
be used for children weighing 10 kg (22 lbs) or less in a
rear-facing position. Do not use over 10 kg (22 lbs) or in a
forward-facing position.
IMPORTANT: The anti-rebound bar is required for rear
facing installations.

LUAS Installation

1. Remove the lower
connectors from the
storage slots in the base.
Press the adjuster release
button and pull the strap
to full length. Repeat for
the second strap.
2. The anti-rebound bar is
required for rear facing
installations. Attach the
anti-rebound bar (see
page 26).
IMPORTANT: Keep
fingers away from the anti-
rebound bar connection
points to avoid finger
entrapment or pinching.
3. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
24). Ensure that no more
than 7.6 cm (3 in.) of the
base hangs over the edge
of the vehicle seat.
4. Firmly press the lower
connectors onto the
adjacent lower anchors
until a click confirms
attachment.
5. Push the child seat
down while pulling each
lower connector strap to
tighten.
8
Rear-Facing Installation with LUAS
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 7.6 cm (3 in.) of the base hangs
over the edge of the vehicle seat.
9 Ensure that the anti-rebound bar is properly installed
(see page 26).
9 Check that the child seat cannot be moved front to back
or side to side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 The child seat is correctly installed when angle guide line
is parallel to the ground when the car is parked on a level
surface. After the child is secured, the recline angle of the
7.6 cm
child seat should be 30° – 45° from vertical (not to exceed
45°) when the car is parked on a level surface. See "Seat
Positions" on pages 24 - 25.
9 Ensure tether webbing is stored in storage pouch. See
page 30.
1
EMBLEM/ALLEGIANCE Canadian User Guide
9