Britax B-SAFE 35 Mode D'emploi

CAUTION:
Your infant car seat carry handle may crack or fracture while carrying it, causing risk of injury to
your child. Please follow the instructions below before further use of the carry handle. If your carry handle is
already cracked or broken, please contact Britax Customer Service.
Tools Required: Hex Wrench (included)
Carry Handle Bracket Installation
1
1
2
3
4
2
Red
release
lever
3
4
Customer Ser vice:
800.683.2045 or
britax.recall@britax.com
All manuals and user guides at all-guides.com
Remove your child from
the infant car seat then
lock the infant car seat
carry handle in position 4.
NOTE: Position 4 is
below horizontal. It may
be necessary to tilt the
infant car seat forward in
order to engage.
Turn the infant car seat
upside down and rotate
so that the red release
lever is toward you.
Align the logo on the carry
handle bracket with the
logo on the infant car seat
carry handle.
Wrap the bracket around
the carry handle while
maintaining proper
alignment of the Britax
logos.
IMPORTANT: The logo
on the carry handle
should be completely
covered by the bracket.
B-SAFE 35 / B-SAFE 35 ELITE
®
5
6
Fasteners
7
Inner sides
8
Britax Child Safety, Inc., 4140 Pleasant Road, For t Mill, SC 29708, U.S.A.
© 2016 Britax Child Safety, Inc. All rights reser ved.
Carry Handle Kit
Tip up the infant car seat
so that it is resting on the
carry handle.
Use one hand to apply
pressure and hold the
bracket closed. Then
use your other hand to
engage and firmly tighten
both fasteners into the
bracket with the hex
wrench.
The fasteners are tight
when the inner sides of
the bracket are flush.
The remedy is now
complete and your infant
car seat carry handle is
safe for normal use. If
you have any questions,
please contact Britax
Customer Service.
For a video of this
procedure please visit
www.bsafe35recall.com.
w w w.Britax.com
P04466800_A:01.16