Other User Settings 6 - Brink Renovent HR Medium Consignes D'installation

Chapter 6
A saved and stored;
B removed;
C put back to factory setting.
A Simultaneously press keys "F"
and "+ F than + ) to store
value.
Press key "OK" to go back to
the settings menu; if required,
several settings can now be
sive).
Now continue with item 6.
B Press key "OK" to go back to
the settings menu without sa-
previous setting will be main-
tained. If required, several set-
item 2 to 5 inclusive). Now con-
tinue with item 6.
6.3 Other user settings
In addition to the air quantities per setting, the user can also
adjust the following parameters.
U4. Minimum atmospheric temperature bypass. This is the
minimum atmospheric temperature at which the bypass
conditions.
U5. Minimum indoor temperature for the bypass. This is the
minimum indoor temperature at which the bypass opens,
ditions.
18
-
-
-
-
Renovent HR Medium/Large
Putting into operation
C Simultaneously press keys "F"
and "-" to go back to the factory
setting. The factory setting will
The factory setting remains on
the display.
Press key "OK" to go back to
the settings menu; if required,
several settings can now be
sive).
Now continue with item 6.
6. Press key "F" during 1 second to
leave the settings menu.
U8 Not applicable
These setting possibilities are only relevant if the appliance is
equipped with a bypass. These bypass settings are made in
the same manner as described in section 6.2. Refer to the table
in section 6.7.3 for the factory settings.
-
5385-0