Modifying Settings 6; Modifying Settings By The User 6.7; Modifying Settings By The Installer 6.7 - Brink Renovent HR Medium Consignes D'installation

Chapter 6
6.7 Modifying settings
6.7.1 Modifying settings by the user
The user can modify a limited number of settings, that is U1 to
U8 inc. (see table section 6.7.3); how to modify these settings
6.7.2 Modifying settings by the installer
The installer can modify more settings. When parameters
are set incorrectly, the appliance can no longer perform up to
Also refer to the diagram menu structure section 6.5.. The fol-
lowing actions are required to modify the settings from opera-
tional mode:
(By way of example parameter 18 (bypass mode) is changed
from 1 to 2.)
1 Press key "F" during 3 seconds
to activate the settings menu.
2 Press key "F" and key "OK" du-
ring 3 seconds to activate the
comprehensive installer parame-
ters set.
3 The desired parameter can be
found with the aid of keys "+" and
"-".
(See table section 6.7.3)
4 Pressing key "OK" calls up this
setting.
5 Use keys "+" and "-" to modify the
value.
22
is described in detail in section 6.2 and is also shown in the
diagram menu structure of section 6.5.
A
B
C
A Simultaneously press keys "F"
and "+
setting; this value now blinks 3x
red; the value remains on the
display.
Press key "OK" to return to the
>3s
settings menu; if required, other
(step 2 - step 5)
Continue with step 7.
B Press key "OK" to go back to
the settings menu without sa-
>3s
previous setting will be main-
tained.
Continue with step 7.
C Simultaneously press keys "F"
and "-
to go back to the factory setting.
The factory setting will blink 3
times and remain at that value.
been removed.
Press key "OK" to return to the
settings menu.
Continue with step 7.
7 Press key "F" during 1 second to
leave the settings menu.
Renovent HR Medium/Large
Putting into operation
be saved and stored
be removed;
be restored to factory setting.
F" and then "-" ) "
-
5423-0